top of page

SupaFix tile grouts are available in grey and white colours

SupaFix Grey & White Tile Grout

 

Cement-based tile grouts designed to point tile joints (2 - 8 mm) on walls and floors. Produced from carefully selected raw materials for consistency of product, it only requires the addition of water on site.

Supafix Grey Grout 5kg

SKU: KHA-S005
$3.92Price
VAT Included
Quantity
  • Features & Benefits

    • High bond strength
    • Interior and exterior application
    • Good workability - easy to mix and apply
    • Consistent quality
    • Suitable for wall and floor use
    • Water resistant

    Surface Preparation

    • Minimum joint width should be 2mm for walls and 3mm for floors.
    • Do not butt-joint tiles.
    • Adhesive should be left to dry for at least 24 hours before grouting.
    • Ensure that the tiles and joints are clean and free from grease or any other contamination.

    Mixing

    • Mix approximately 1.5litres of clean water to 5kg of SupaFix Tile Grout to produce a thick creamy paste.
    • Allow the mixture to stand for 5 minutes.
    • Remix thoroughly before use.
    • If SupaFix Tile Grout is used in permanently wet areas, areas where food or cosmetic staining may occur, e.g. kitchens and bathrooms or if increased flexibility is required, the water in the mix should be replaced with SupaFix Bonding Liquid
    • Note that the grout will dry a shade darker. Do not add too much water or attempt - to extend the working time by adding more water as this will cause the set grout to be weak with a tendency to crumble. It may also cause surface discolouration and variation, especially with darker colours.

    Application

    • Using a squeegee or rubber float, apply SupaFix Tile Grout Tile Grout liberally to a small area. Completely fill the joints leaving no voids.
    • Excess grout should be removed immediately using the grout squeegee held at 90 degrees to the tiles.
    • Move the squeegee diagonally across the tiles to prevent removal of the grout within the joints. Leave the grouted joints to harden for approximately 2 hours. The excess grout can then be cleaned off with a damp (not wet) sponge.
    • Do not leave excess moisture on grout joints.
    • The joints can be finished off by pointing along the joint lines.
    • Allow the joints to dry for 24 hours before polishing with a clean, dry cloth.

    Storage & shelf life

    When stored, unopened in a dry place at temperatures above 5°C, shelf life is 12 months from date of manufacture.

    Health & Safety

    • Harmful by inhalation and irritation to eyes
    • Use rubber gloves and dust masks
    • In case of contact with eyes, wash out with plenty of water
    • Get medical attention if symptoms persist
No Reviews YetShare your thoughts. Be the first to leave a review.

Related Products

3 Martin Road, Msasa, Harare

+263 772 204 044 / info@ef4tiles.com

  • Facebook
  • Instagram

© 2024 by Earthen Fire & Simplistic

bottom of page